Home :: Water feature installation

Water feature installation

Water Feature Installation:

Note: Under the new electrical installation requirements for UK, DIY external installations are not allowed, they must be done by a qualified professional electrician more..

JapanGarden.co.uk can supply reservoirs, pumps and lighting for your installation

1. Mark out the Pre-formed Reservoir - Using a pre formed reservoir saves a great deal of time

2. Dig appropriate size hole and place reservoir so that it is level and firm. For very heavy granite structures, concrete under the wings for extra strength

3. Place the feature on the reservoir and feed the hose through from the top of the feature - (ensure you have plenty of hose available) Tape or silicone the gap between hose and granite to prevent water running back inside the feature

4. If you are using a Spotty Light, feed the light up through the feature from the bottom end - leave it clear of the hose to increase water flow

5. Coil a piece of soft wire around the thight and push it into place ( The wire will stop the light moving when the water is flowing

6. Cut a small slit in the hose and pull the cable for the light into the slit ( this can be sealed with silicone)

7. Attach hose to pump using Jubilee Clip available from local DIY

8. Put the pump into the reservoir and you are finished - 12v Transformers must be inside or in the dry, Pumps must be on a protected circuit breaker supply

9. Finished

This is the Diamond Sculpture available here - Dont forget you can see our wide range of specimen rocks and cobbles to enhance your water feature here

Note: Under the new electrical installation requirements for UK, DIY external installations are not allowed, they must be done by a qualified professional electrician more..